| Home  | About ScienceAsia  | Publication charge  | Advertise with us  | Subscription for printed version  | Contact us  
Editorial Board
Journal Policy
Instructions for Authors
Online submission
Author Login
Reviewer Login
Volume 50 Number 1
Volume 49 Number 6
Volume 49 Number 5
Volume 49S Number 1
Volume 49 Number 4
Volume 49 Number 3
Earlier issues
Volume  Number 

previous article next article

Research articles

ScienceAsia 40 (2014): 232-237 |doi: 10.2306/scienceasia1513-1874.2014.40.232


Electrospun fibres from polyvinyl alcohol, poly(styrene sulphonic acid-co-maleic acid), and imidazole for proton exchange membranes


Romklaw Boonpoo-ngaa, Manus Sriringa, Pitak Nasomjaia, Surangkhana Martwisetb,c,*

 
ABSTRACT:     Electrospun fibres from polyvinyl alcohol (PVA), poly(styrene sulphonic acid-co-maleic acid) (PSSA-MA), and imidazole for potential use as proton conducting membranes at elevated temperatures were prepared and characterized. The effect of PSSA-MA content (9, 17, 25, 33, 42, and 50% by weight of PVA) on solution properties was investigated. Fibre mats were obtained from solutions with 9–33% PSSA-MA. Solution viscosity increased with increasing PSSA-MA until reaching a maximum at 33% PSSA-MA. The effect of PSSA-MA content on fibre size and morphology was studied using scanning electron microscopy. Fibre diameter was found to increase with increasing solution viscosity. A solution with 25% PSSA-MA provided uniform and bead-free fibres with an average diameter of 485 nm. Thermal crosslinking of electrospun fibres was confirmed by attenuated total reflection Fourier transform infrared spectroscopy and thermogravimetric analysis. Electrospun fibres were thermally stable up to 250 °C. Fibres containing 25% PSSA-MA had a proton conductivity in non-humidified conditions comparable to that of a solvent-cast membrane with the same composition. The proton conductivity of a solvent-cast membrane was slightly higher than that of fibres over the temperature range studied.

Download PDF

47 Downloads 1386 Views


a Department of Chemistry, Faculty of Science, Khon Kaen University, Khon Kaen 40002 Thailand
b Materials Chemistry Research Centre, Department of Chemistry and Centre of Excellence for Innovation in Chemistry, Faculty of Science, Khon Kaen University, Khon Kaen 40002 Thailand
c Nanotec-KKU Centre of Excellence on Advanced Nanomaterials for Energy Production and Storage, Khon Kaen 40002 Thailand

* Corresponding author, E-mail: surama@kku.ac.th

Received 18 Dec 2013, Accepted 5 May 2014